Description
212x104p 2.13 Inch E Ink Display HAT for Raspberry Pi and Jetson Nano
Getting Started with 2.13-inch E-Paper HAT
The 2.13-inch e-Ink Display HAT works with Raspberry Pi and NVIDIA Jetson Nano. This display HAT supports the SPI interface and the screen resolution is 212×104 pixels. The 2.13-inch e-Paper HAT is a 3 color display, i.e. Black, Red, and White. There is an embedded controller on the display HAT.
It is ultra-low-power hardware because it uses electricity only when the new content is loaded. The display can hold the content for a long time without requiring power. This compact display HAT is ideal for shelf-labeling as well as industrial instruments.
Paper Like Experience – Less Stress on the Eyes
Features of 2.13-inch e-Ink Display HAT for Raspberry Pi and Jetson Nano
- Brand: Waveshare
- Interface Support: SPI interface for data transmission
- Compatibility: Raspberry Pi and NVIDIA Jetson Nano
- Solder Pads are preserved for SPI interface to establish a connection with Arduino and Nucleo
- Ultra-Low-Power hardware – No backlight
- Power is only required for uploading or refreshing content
- Compatible with 40Pin extension (Standard Raspberry Pi Header)
- 3V ~ 5V MCUs – Onboard voltage translator
SPI Control Interface Onboard Supports Controller Boards such as Raspberry Pi, Jetson Nano, NVIDIA, STM32…
Specifications of 2.13-inch e-Ink Display HAT for Raspberry Pi and Jetson Nano
- Operating Voltage: 3.3V ~ 5V
- 4-Wire and 3-Wire SPI interface
- 212×104 pixels resolution
- Dot Pitch: 0.229 x 0.228
- Display Colors: White, Black, and Red
- Grey Level 2
- Full Refresh Time: 15 seconds
- Refresh Power (typ.): 26.4mW
- Standby Power: Less than 0.017mW
- View Angle > 170o
- Weight: 0.021 Kg | 21 grams
- Display Dimensions: 2.371cm x 4.855cm | 23.71mm x 48.55mm
- Outline Dimensions: 6.5cm x 3.02cm | 65mm x 30.2mm
Note
- It takes approximately 0.3 seconds for a partial refresh
Items Included
- 1x 1.13-inch e-Ink HAT
- 1x PH2.0 8-Pin (20cm)
- Screws
This offer does NOT include Raspberry Pi.Â
